UK-10
RADIO OPERATION
Press the FUNCTION button to select the TUNER mode on the unit (or remote control),you can
select the radio operation.
Note:
Extend the FM antenna for better FM reception.
1. Press the /BAND button to select wave band range (MW or FM) appearing on the display.
2. Select the desired frequency with the or button.
Manual Tuning
To tune for weak stations, use manual tuning by pressing the or button continuously until you
tune to the correct frequency or the reception is at its best.
Mono/ Stereo Select
You can use this function only in FM mode.
1. When you want to select FM stereo effect , press the INTRO/MONO/ST. button on remote
control. When you receive an FM stereo station the " " indicator will appear on the display,
which means FM stereo transmission is received.
2. When you press the INTRO/MONO/ST. button again, the FM STEREO indicator will turn
off & switch to MONO FM status.If your desired station is weak and noisy, switch to MONO to
reduce the noise.
Automatic Tuning
1. Press the or button for a few seconds, then release the button.
The tuner will automatically search the first station which has sufficient signal strength.
2. Repeat the above steps if you wish to select another station.
Programming preset stations
You can also preset stations of your choice and store up to 10 MW and 20 FM stations
in the unit’s memory. To store your selected broadcasting stations:
1. Press the /BAND button on the unit(or remote control) to select between MW and FM to
make your selection.
2. Tune to the desired station.
3. Press the ERASE/MEMORY button.
4. Press the RANDOM/MEM-DOWN or REPEAT/MEM-UP button to select your desired preset
number.
5. Press the ERASE/MEMORY again to confirm your selection.
6. To program more stations into memory, repeat the above 2 to 5 steps .
7. To change the stored preset stations, repeat the above 2 to 5 steps.
Note:
1. Storing a new station into a preset location will erase the previously stored station in that
location.
2. The stored stations will be saved even if you power off the unit.
3. When
ress the button and ENCODING button to erase
all preset memory.
Selecting the Preset Stations
1. Press the /BAND button to select the desired band.
2. Press the RANDOM/MEM-DOWN or REPEAT/MEM-UP button to select the desired preset station
number.
3. The numeric location of that preset station is displayed along with the corresponding
frequency.
the unit is in STANDBY mode, p
AUDIO SOURCE SELECT
Press the FUNCTION button to select the audio mode as below :
CD
CARD
AUX
USB
TUNER
BLUETOOTH
