Hitachi 22LD4500, Инструкция по эксплуатации, Страница: 57 / 71

56
Picture Mode
Picture mode OSD is displayed when “ WIDE ”
key is pressed. Picture mode can be changed to
Auto, 4:3, 16:9, Cinema, Subtitle, Zoom or
Panorama by pressing “ WIDE ” key..
Sleep Timer Indicator
It is displayed on the upper right of the screen when a
new programme is entered by digit key or by press-
ing “ P<P ”, “-P/CH”, “P/CH+” , “ TV ”, “ AV ” or
“ ” key. If sleep timer is activated it is displayed
with the TV status and erased with it after 3 seconds.
Once the time set with the sleep timer has elapsed,
the set will go to standby.
0:15
Mute Indicator
It is placed in the upper middle of the screen when
enabled, and it stays there until it is disabled.
To cancel mute, there are two alternatives; the first one
is pressing " " key, the volume is set to the preced-
ing value. The second one is increasing the volume
level, whereby it starts at the minimum level to in-
crease. By decreasing the volume level in mute state,
mute will not be ignored, only the volume level will de-
crease. If mute is cancelled after decreasing the vol-
ume level, the volume will be set the decreased level.
No-Signal Detection (TV)
If no valid signal detected, it takes 5 minutes for the
set to switch to Standby mode unless a signal is de-
tected or a command is received from the remote
control.
After a Remote Control command (if No-Signal Timer
is active) the timer stops and if no signal detected
again the timer is initialized to 5 minutes and starts 3
seconds later again to count down.
It is not valid in AV mode.
4:31
No-Signal Detection (PC)
If no valid signal detected for 5 minutes system goes
to Stand-By mode. To switch on the system press
“ ” key..
As the last status feature, system starts from TV or
PC, whichever was the status before stand-by or
switch-off. Note that SCART inputs have the prece-
dence on both TV and PC.
Volume Bar
It is displayed in the lower middle of the screen. When
a volume command is received (pressing
“ +”
or “ -” by Remote Control or Control panel at
the top of the TV) and no menu is active, it stays on
the screen for 3 seconds, after the last volume com-
mand or until another command is received in be-
tween.
AV Modes
By pressing the “ AV “ key you can switch your TV to
AV modes (except being in Teletext). Pressing this key
will consecutively switch the TV in one of the optional
AV modes: AV-1, AV-2, AV-3, S-VIDEO, PC.
In order to quit the AV mode press the “
TV ”, digit
keys or “-P/CH” or “P/CH+” .
Signal Out Of Range
When the PC input signal is not supported by LCD-
TFT TV, a message is displayed like “Signal out of
range” and screen is blanked.
1549 UK-IDTV TV-DVB-22'' TFT IB-2-(Revised - 19x27).p65 01.12.2004, 13:49 56