Hisun Motors HS 244-2, Руководство по введению

Страница: 45 / 65

Periodic Service
10-13
partially charge the battery as early as
possible.
3. When exchanging an old battery for a new
one use battery of equal specification shown
in table 1.
Battery type Volts
12V32Ah 12
◆
Direction for storage
1. When storing the vehicle for a long period,
remove the battery from the vehicle, store in
a dry place out of direct sunlight.
2. The battery shall self self-discharge while it
is shored recharge it once every three
months in hot seasons and once every six
months in cold seasons.
■
Adjusting toe-in
Proper toe-in 0 to12 mm (0 to 0.47 in)
1. Park vehicle on flat place.
2. Turn steering wheel so front wheels are in
the straight ahead position.
3. Lock the park brake and stop the engine.
4. Measure distance between front tire beads
at rear of tire at hub height.
5. Front distance should be shorter than rear
distance if not adjust tie rod length.
①
Wheel-to-wheel distance at front
②
FRONT
◆
Adjusting procedures
1. Loosen the lock nut and turn the tie rod to
adjust the rod length until the proper toe-in
measurement is obtained.
2. Retighten the lock nut.
IMPORTANT

Keep the equal length of the left and right
tie-rod.
■
Cleaning Muffler
CAUTION
To avoid personal injury:

Before touching any part of an exhaust
system, be absolutely sure that it has
sufficient time to cool!

Always wear safety goggles and face
mask.

The particulate matter contained in the
muffler contains chemicals that are
harmful to people, animals and marine
life.

If you are unable to do this work, have it
done by your dealer.

Cleaning spark arrester of muffler.
Maintenance & cleanout procedure: