Hirschmann PowerMICE MB-2T, Руководство пользователя

Страница: 35 / 58

PowerMICE
Release 01 04/2014
35
Figure 14: Pin assignment of an AUI interface
1 - Pin 1: Shielding CI
2 - Pin 2: Output CI-A
3 - Pin 3: Input DO-A
4 - Pin 4: Shielding DI
5 - Pin 5: Output DI-A
6 - Pin 6: GND
7 - Pin 7: not connected
8 - Pin 8: Shielding CO
9 - Pin 9: Output CI-B
10 - Pin 10: Input DO-B
11 - Pin 11: Shielding DO
12 - Pin 12: Output DI-B
13 - Pin 13: Voltage 12 V
14 - Pin 14: Shielding 12 V
15 - Pin 15: not connected
2.2.12 Installing the MB-2T expansion module
The MB-2T expansion module enables you to add 2 slots for media modules
to the basic module. You can install the expansion module while the device
is operating.

On the right side of the basic module, loosen the screws at the top and
bottom (1-3 revolutions).

Take off the side panel.

If you have not already done so, mount the basic module on the DIN rail.

Push the expansion module on the DIN rail to the basic module until the
modules are plugged together.

Tighten the screws on the top and bottom of the basic module again.
3
2
7
6
5
4
8
1
11
10
15
14
13
12
9