Hirschmann Octopus II, Руководство пользователя

Страница: 35 / 66

Installation Octopus II
Release 06 10/2018
35
To protect the exposed uninstalled contacts of the components from dirt,
connect the individual system components in a dry and clean working area.
Note: Exclusively for device variants featuring temperature range
characteristic value T:
Mount the device on a 1.62 sq ft (0.15 m²) large, 0.09 in (2 mm) thick metal
plate to which you do not connect any other heat source. Otherwise the
maximum ambient temperature is reduced by 5 K.
See “General technical data” on page 49.

Prepare the drill holes at the installation point.

Mount the device on a level surface with 4 M5 screws.

To preserve the suitability of your device for IP65/67, proceed as follows:

Remove the provided transport protection caps and the transport
protection screws from the device.

Seal unused sockets and plugs with your desired type of protection
screws which you can order separately.
2.2.2 Grounding the device
Grounding the device is by means of a separate ground connection on the
device.
The overall shield of a connected shielded twisted pair cable is connected to
the ground connection on the metal housing as a conductor.
The device variants have a connection for protective grounding.
Note: Use toothed washers to ensure good electrical conductivity at the
connection.

Ground the device via the provided M4 screw.
M4x8