Hirschmann EAGLE 20 Series, Справочное руководство

Страница: 19 / 40

CLI EAGLE 20
Release 5.0 08/2010
19
The following table shows the command modes, the command prompts (in-
put request characters) visible in the corresponding mode, and the option
with which you quit this mode.
If you enter a question mark (?) after the prompt, you receive a list of the
available command and a short description of the commands.
Figure 9: Commands in the User Exec mode
Command
mode
Access method Quit or
start next mode
User Exec mode First access level. Perform basic
tasks and list system information. To quit you enter
logout
:
(Hirschmann Eagle) >logout
Are you sure (Y/N) ?y
Privileged Exec
mode From the User Exec mode, you enter
the command
enable
:
(Hirschmann Eagle) >enable
(Hirschmann Eagle) #
To quit the Privileged Exec mode and
return to the User Exec mode, you
enter
exit
:
(Hirschmann Eagle) #exit
(Hirschmann Eagle) >
Global Configura-
tion mode From the Privileged Exec mode, you
enter the command
configure
:
(Hirschmann Eagle) #config-
ure
(Hirschmann Eagle) (con-
fig)#
From the User Exec mode, you enter
the command
enable
, and then in
Privileged Exec mode, enter the
command
Configure
:
(Hirschmann Eagle) >enable
(Hirschmann Eagle) #config-
ure
(Hirschmann Eagle) (con-
fig)#
To quit the Global Configuration
mode and return to the Privileged
Exec mode, you enter
exit
:
(Hirschmann Eagle) (con-
fig)#exit
(Hirschmann Eagle) #
To then quit the Privileged Exec
mode and return to the User Exec
mode, you enter
exit
again:
(Hirschmann Eagle) #exit
(Hirschmann Eagle) >
Table 1: Command modes
(Hirschmann Eagle) >?
enable Turn on privileged commands.
help Display help for various special keys.
history Show a list of previously run commands.
logout Exit this session.
ping Send ICMP echo packets to a specified IP address.
show Display device options and settings.
traceroute Trace route to a specified host.