Then get a CCW motor (double check you’ve got the right one!) and align it so its wires
are pointed toward the center of the frame. Then line up the screw hole in the bottom of
the motor with the tip of the screw sticking out of your frame. Screw in the motor until it
is firm, but not so firm you can’t swivel the motor a bit to get the other three holes to line
up. Then screw in the other three screws.
Once you’ve got all four screws in
place, go back and tighten all four
screws firmly but not too tightly.
The head of the screw should be
flush with the wood mount. DO
NOT OVERTIGHTEN. If you screw
in as hard as possible, you’ll drive
the screw into the motor’s internal
parts and permanently damage it.
If you’re sinking the screw into the
wood, you’ve gone too far. Just a
firm fit is good.
