www.HiotH.com
Smart Photoelectric Smoke Sensor Installation
1.
Anticlockwise rotating the bracket out from the installation base, then remove the battery
insulating strip to make detector on power.
Factory default built in a CR123A 3V lithium battery inside the detector and used a Mylar
film to isolate batteries from electric circuit of the detector. Remove the battery Mylar film
when ready to let the detector work.
If there is no battery inside the detector or need to replace a new battery, please insert the
battery first.
Fig.6
2.
Make sure the device has been included into the network normally.
3.
Remove the double-sided adhesive membrane on the mounting bracket, and rotating the
smoke alarm into the bracket.
Fig.7
