HIOS BLOP-STC 3, Руководство по эксплуатации

Страница: 3 / 28

Introduction
Thank you for purchasing the BLOP-STC 3, CLT-70STC 3 screw counter. Prior to use,
please read through this operating manual to enable proper use of the equipment. After use,
keep this manual in a safe place.
■
Summary
When tightening screws, it is necessary to verify that the operator has tightened the stipu-
lated number of screws for 1 work piece to prevent forgetting to tighten screws. The Screw
counter has been developed as a power supply unit with a screw counting function to relieve
the burden on operators, to improve operating efficiency and to prevent careless mistakes.
■
Counting function
1. This device can be set to tighten between 1 and 99 screws, depending on the work
piece, and for each screw tightened, the display of the number of screws remaining is
reduced by one.
2. When the final screw is tightened, a buzzer sounds to prevent forgetting to tightening
a screw. This also permits confirmation of completion of work.
3. After completion of tightening screw, the display of the number of screws is automati-
cally renewed using an auto reset function, and the electric screwdriver will not oper-
ate until the set signal for confirmation of the work piece is received.
* Screwdriver operation in standby mode can be prevented.
4. Prevents counting of confirmation tightening and additional tightening (tightening
screws a second time).
5. The equipment can be set not to count cases where a screw is not fully seated,
obliquely tightened or where tightening is insufficient*.
* Depends on type of work being performed.
■
Other functions
1. The external device control function enables solenoid valve control of a jig to fix work
in place, and utilization of a commercially available total counter to count the total
number of work pieces completed.
2. In multiple counter mode using the external connection function, careless mistakes
can be prevented independently of the operator by operating several electric screw-
drivers for different numbers of screws or with different output torques in order of the
work being performed, for example in cell manufacturing, etc.
3. This equipment also has a normal power mode, where the counter function is disabled
and it functions as a normal power supply unit.
- 2 -