HIOS BLOP-STC 3, Руководство по эксплуатации

Страница: 19 / 28

■
Work instructions
1) Turn on the main power switch.
2) Tighten the first screw.

The number of screws display is lowered by one.
3) After tightening the set number of screws, tightening of screws is finished.
•
The number of screws display reaches “00” and the complete buzzer sounds.
•
Afterwards, it is automatically reset and the initial setting for the number of screws to
tighten is displayed.
• This work can be repeated.
3. Counter mode
✽
Use this mode when controlling an electric screwdriver for each piece of work and fixing
of work piece using the external device function.
✽
The total number of work pieces completed can be counted by connecting a commercially
available total counter.
■
Connections
1) Connect the connector for the screwdriver cord to the metal connector of this equip-
ment.
2) Connect the power supply cord for this device to a power supply that supplies the rated
power (AC outlet) and connect to ground.
3) Make connections for each control signal with reference to Fig. 1.
■
Setup instructions
1) Turn on the main power switch.
2) Set 00 in the System Setting Mode (F1 Display " ").
3) Set the number of screws to be tightened using the Count Setting Mode (F1 Display
" ").
4) Set the Work Set Timer operating time to suit the work piece using the WS-T Setting
Mode (F1 Display " ") switch (range from 0 second to 3.9 seconds).
5) Set the Counter Timer operating time using the CN-T Setting Mode (F1 Display " ")
switch (range of 0.01 second to 0.99 second) while performing confirmation tightening.
6) Set the Work Reset Timer operating time to suit the work piece using the WR-T Setting
Mode (F1 Display " ") switch (range from 0 second to 3.9 seconds).
7) Exit the Setting Mode by pressing the F1 switch for longer than 1 second.
8) Preparation settings are now complete.
- 18 -