Hioki 9518-02, Инструкция по эксплуатации, Страница: 35 / 86

29
────────────────────────────────────────────────────
5.3 Standard Commands
────────────────────────────────────────────────────
128 64 32 16 8 4 2 1
bit 7 bit 6 bit 5 bit 4 bit 3 bit 2 bit 1 bit 0
PON URQ CME EXE DDE QYE RQC OPC
Standard event status enable register (SESER)
5.3 Standard Commands
*
CLS
■ Clears the status byte register and the event registers.
*
ESE
■
Sets the standard event status enable register.
Syntax
*
CLS
Function
･
Clears all the event registers (SESR, ESR0) associated with the bits of the
status byte register. Accordingly, also clears the status byte register.
･
This has no effect upon the output queue, the various enable registers, or bit 4
(the MAV bit) of the status byte register.
Error
If the data parameters are set after this command, a command error occurs.
Syntax
*
ESE
_<data>
<data>
Numerical data in NR1 format between 0 and 255
Function
･ Sets the standard event status enable register (SESER) to a bit pattern which
is used to mask the standard event status register (SESR).
･ The numerical value can be in NRf format, but any digits after the decimal
point will be rounded.
･ When the power is turned on, the data is reinitialized to zero.
Example
Transmission
*
ESE
20
Bits 2 and 4 of SESER are set to 1.
Error
If <data> is other than numerical value described above, an execution error
occurs.