Hioki 9196, Инструкция по эксплуатации

Страница: 36 / 44

10
2 Operation
HIOKI
6.
Applying voltage.
(1) Make the appropriate settings based on the type and volt-
age polarity of the equipment to be measured.
Set the type based on the type of applied part of the equip-
ment to be measured.
B/BF No protective resistance applied to the output.
CF Protective resistance applied to the output.
The protective resistance (10 k
Ω
) is connected to
the internal output circuit in series. If the output cur-
rent is large, the protective resistance cause a
reduction in voltage, and the actual output voltage is
reduced.
Set the voltage polarity.
NORMAL Polarity conforms with that of the voltage input
from the power inlet.
REVERSE Polarity does not conform with that of the volt-
age input from the power inlet.
(2) Apply the voltage.
If the
3155 LEAK CURRENT HiTESTER
and the equipment to
be measured are ready, touch the tip of the
9190 VOLTAGE
APPLY PROBE
to the contact point. After verifying that
there is no danger of electrical shock, press the voltage
application button to the
9190 VOLTAGE APPLY PROBE
with
your finger. If the red output monitor lamp
(OUTPUT MONI)
is illuminated while pressing the voltage application button,
the voltage is being output.
(3) Cease application of voltage.
Release your finger from the voltage application button.
7.
Set the main power switch on the front of the unit to OFF.
Voltage appli-
cation button