Hinton Equipment Flametech Lite, Руководство по сборке и эксплуатации

Страница: 6 / 12

7. Close the oxygen torch valve.
8. Repeat the same procedure with the fuel gas.
LIGHTING AND SHUT DOWN PROCEDURES
Before lighting the torch always, follow all personal and equipment safety regulations. Wear safety
glasses and filtered protective eyewear to protect the eyes from heat, sparks and hazardous rays of
light produced by the flame. Overalls, safety shoes, leather aprons and gloves may also be required.
LIGHTING PROCEDURE
1. Follow the instructions in this manual pertaining to set up, leak testing and purging practices prior
to lighting the torch.
2. Using the nozzle chart, identify the working oxygen and fuel gas pressure for the nozzle size being
used.
3. Ensure that the pressure-adjusting knobs on both regulators are fully open.
4. Close both the fuel gas and oxygen torch valves.
5. Open the oxygen cylinder valve slowly to ensure the regulator is not damaged by the surge of high-
pressure gas.
6. Open the oxygen torch valve one full turn.
7. Using the oxygen regulator pressure-adjusting knob set the pressure identified from the nozzle
chart.
8. Close the oxygen torch valve.
9. Repeat the procedure on the fuel gas.
10. Open the fuel gas torch valve about one turn, using an approved friction or cup spark lighter to
ignite the fuel gas.
11. Increase the fuel gas flow until the flame is about to leave the end of the nozzle.
12. Slowly open the oxygen torch valve. Continue to open the oxygen valve until the flame of your
choice is achieved.
Page 6
Flametech Lite Assembly & Safety Instructions