Copyright © 2020
5. Remove the Piston.
−
Remove the retainer rings installed on both ends of the piston, using retainer ring
pliers.
−
Strike out the piston pin.
NOTICE:
Warm up the piston first in hot water, 80-90
C {176-194
F}, for approximately 5
minutes before removing the piston pin.
6. Remove the Crankshaft.
−
Remove the bearing holder fitting screw.
−
Use the press to remove the crankshaft together with the bearing holder.
NOTICE:
Be careful not to damage the bearing holder.
7. Remove the Bearing Holder.
−
Use the press to remove the bearing holder.
NOTICE:
Be careful not to damage the bearing holder.
8. Remove the Ball Bearing.
−
Using the special tool, remove the ball bearing from the end of the crankshaft.
Assemble
1. Install the Ball Bearing.
−
Install the ball bearing onto the both ends of the crankshaft.
