Copyright © 2020
−
Place a guide stud bolt (M8 x 1.25, length: 50 mm {1.968 in.} or more) in the flywheel
housing as shown in the figure and insert the compressor onto the stud bolt.
−
Tighten the mounting bolts (other than the stud bolt) then remove the stud bolt. Insert
a bolt in the place of the stud bolt.
Tightening Torque:
28.5 N
m {290 kgf
cm, 20 lbf
ft}
−
Make sure that the aligning mark "0" on the top of coupling flange is aligned with
protrusion on the compressor housing.
2. Install the Supply Pump and Air Compressor.
