HM160 MAX
10
European key operation
Most of the functions in the radio are the same as the US model. These are the functions that work
differently.
Programming ATIS ID
ATIS function only exists in European Model. Therefore, it only functions when the European radio is tuned to the
International Frequency Group. After ATIS ID is being program into the radio via the keypad or the cloning software,
the ATIS function will be enabled all the time. The user cannot disable it.
To enable the customer to enter ATID ID into the radio from the keypad, the check box next to the ATIS entry by user
on the Cloning software has to be ticked.
Programming ATIS ID from the Keypad
1. Programming start with the radio turn OFF.
2. Long press H/M/L/Lock and turn radio ON to access the ATIS mode.
3. The front digit will indicate the digit position of the ATIS ID. The rear digit will blink continuously. The rear digit
indicates the ATIS ID. Changing the value of the rear digit can be achieved using the coding knob.
4. Press “MEM” key to confirm the selection and move to the next digit.
5. After the user complete the 9 digit ATIS ID, the user has to enter the ATIS ID the second time to avoid invalid
entry. If different ATIS ID is entered, operation will be canceled The user has to repeat step one to initiate the
ATID ID entering sequence.
6. After entering a valid ATID ID for the second time, the ATIS ID will be flashed in sequence one time on the
screen, and the radio will revert into previously working channel saved in the memory before the radio is turn
off. If no channel is found in the memory, the radio will revert to CH16 at High Power setting
7. Store the ATIS ID permanently into the radio by turning the radio off.
8. After the ATIS ID being programmed into the radio, from OFF position holding H/M/L and
turning the radio ON will make the radio flash its ATIS ID. After this stage, only with the cloning
software the ATIS ID be modified or erased.
ETC
….
..
ETC
….
..
