HIMS BLAZE ET, Быстрый старт

Страница: 8 / 21

Quick Start Guide
– Blaze ET
5
2.5. The Back Face
Flip the Blaze ET over in your hand so that the SD card slot is
now on the right side. The back face or underside of the unit
contains 3 things. At the very top in the center are a couple of
holes for connecting the lanyard
Underneath the lanyard connection is the OCR camera. Below
that is a triangular ridged section. If you press down and
backward on this section, the majority of the back of the unit
slides away to reveal the battery compartment.
3. Inserting and Removing the Battery
As described above, you can access the battery compartment by
sliding the back off of the unit. With the keypad facing down and
the SD card slot facing to the right, locate the triangular ridged
section under the camera on the back of the unit. Press down
and backward on the triangular ridge to release and slide the
back away from the unit.
To insert the battery pack into the unit, hold it so that the edge
with the small ridge is facing toward you with the ridge on the left.
You should also notice a small dot near the bottom left corner of
the top surface of the battery. Place the ridged end into the
bottom of the battery compartment first, then gently press down
on the top of the battery to secure it in place. Slide the back
casing on to the unit and click it into place.
To remove the battery pack, slide the back casing off of the unit.
Place your fingernail between the top of the battery pack and the
edge of the compartment and lift the battery up and out.