Hilti TE 30-ATC, Руководство по эксплуатации

Страница: 27 / 218

Fault Possible cause Remedy
The tool cuts out while running. ATC has been triggered. See section: 7.1 Active Torque Con-
trol
3
No hammering action. The power tool is too cold. Allow the power tool to warm up to
the minimum operating temperature.
See section: 7.3.2 Hammer drilling
The function selector switch is set to
“Drilling without hammering”.
Set the function selector switch to
“Hammer drilling”.
The power tool doesn’t achieve
full power.
The extension cord’s conductor cross
section is inadequate.
Use an extension cord with an ad-
equate conductor cross section.
See section: 6.2 Use of extension
cords and generators or transformers
The control switch is not pressed
fully.
Press the control switch as far as it
will go.
The drill bit doesn’t rotate. The function selector switch is not
engaged or is in the “Chiseling” or
“Chisel adjustment” position.
Move the function selector switch to
the “Hammer drilling” position when
the motor has stopped.
The drill bit can’t be released. The chuck is not pulled back fully. Pull the chuck back as far as it will go
and remove the insert tool.
The drill bit makes no progress. The forward/reverse switch is set to
reverse rotation.
Set the forward/reverse switch to for-
ward rotation.
The drill bit is stuck (not free to
rotate).
The drill bit is stuck in the hole. Release the switch, hold the tool se-
curely and switch on again.
10 Disposal
Most of the materials from which Hilti power tools or appliances are manufactured can be recycled. The materials
must be correctly separated before they can be recycled. In many countries, Hilti has already made arrangements for
taking back your old power tools or appliances for recycling. Please ask your Hilti customer service department or
Hilti representative for further information.
For EC countries only
Disposal of electric tools together with household waste is not permissible.
In observance of the European Directive on waste electrical and electronic equipment and its imple-
mentation in accordance with national law, electrical appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
11 Manufacturer’s warranty - tools
Hilti warrants that the tool supplied is free of defects in
material and workmanship. This warranty is valid so long
as the tool is operated and handled correctly, cleaned
and serviced properly and in accordance with the Hilti
Operating Instructions, and the technical system is main-
tained. This means that only original Hilti consumables,
components and spare parts may be used in the tool.
This warranty provides the free-of-charge repair or re-
placement of defective parts only over the entire lifespan
of the tool. Parts requiring repair or replacement as a
result of normal wear and tear are not covered by this
warranty.
Additional claims are excluded, unless stringent na-
tional rules prohibit such exclusion. In particular, Hilti
is not obligated for direct, indirect, incidental or con-
sequential damages, losses or expenses in connec-
tion with, or by reason of, the use of, or inability to
use the tool for any purpose. Implied warranties of
merchantability or fitness for a particular purpose are
specifically excluded.
For repair or replacement, send the tool or related parts
immediately upon discovery of the defect to the address
of the local Hilti marketing organization provided.
en
24
Printed: 19.08.2013 | Doc-Nr: PUB / 5151646 / 000 / 00