Hilti TE 30-ATC, Руководство по эксплуатации

Страница: 19 / 218

2.3 Switches
Speed control switch for smooth starting.
Forward / reverse switch
Function selector switch:
- Drilling without hammering
- Hammer drilling
- Chisel adjustment (12 positions)
- Chiseling
2.4 Grips
Pivotable side handle with depth gauge
Vibration-absorbing grip
2.5 Protective feature
Mechanical slip clutch
2.6 ATC (Active Torque Control)
Electronic quick switch-off
2.7 Lubrication
Oil lubrication
2.8 Active Vibration Reduction (AVR)
The power tool is equipped with an AVR Active Vibration Reduction system which reduces vibration significantly
compared to power tools without AVR.
2.9 Items supplied as standard
1 Power tool
1 TE‑C chuck
1 Side handle with depth gauge
1 Operating instructions
1 Hilti toolbox or cardboard box
1 Cleaning cloth
1 Grease
2.10 Using extension cords
Use only extension cords of a type approved for the application and with conductors of adequate cross section. The
power tool may otherwise loose performance and the extension cord may overheat. Check the extension cord for
damage at regular intervals. Replace damaged extension cords.
Recommended minimum conductor cross section and max. cable lengths
Conductor cross section
1.5 mm² 2.5 mm² 4.0 mm²
Mains voltage 220-240 V 40 m 70 m 110 m
Do not use extension cords with a 1.0 mm², 1.25 mm² or 2.0 mm² conductor cross section.
2.11 Using extension cords outdoors
When working outdoors, use only extension cords that are approved and correspondingly marked for this application.
2.12 Using a generator or transformer
This tool may be powered by a generator or transformer when the following conditions are fulfilled: AC voltage and
power output of at least 2,600 W, operating voltage must be 5% and -15% of the rated voltage at all times,
frequency must be in the 50 – 60 Hz range and never above 65 Hz, and the unit must be equipped with automatic
voltage regulation and starting boost.
en
16
Printed: 19.08.2013 | Doc-Nr: PUB / 5151646 / 000 / 00