Hilti NPR 019 IE-A22, Оригинальная инструкция по эксплуатации

Страница: 27 / 232

*2188464*
2188464 English 23
9 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to rectify the problem by
yourself, please contact
Hilti Service.
9.1 The crimping / pressing tool is not in working order.
Malfunction Possible cause Action to be taken
The LEDs on the battery indi-
cate nothing. The battery is not correctly in-
serted.
▶
Push the battery in until it
engages with a double click.
Battery is discharged. ▶ Change the battery and charge
the empty battery.
The battery is too hot or too cold. ▶ Allow the battery to cool
down or to warm up to room
temperature.
1 LED on the battery blinks. Battery is discharged.
▶
Change the battery and charge
the empty battery.
The battery is too hot or too cold. ▶ Allow the battery to cool
down or to warm up to room
temperature.
4 LEDs on the battery blink. Product momentarily overloaded. ▶ Allow the product to cool down.
Red LED => lights continu-
ously and a warning tone is
emitted. Technical problem. ▶ Incorrect operation is possible!
Contact
Hilti Service.
Red LED => blinks at short
intervals and a warning tone
is emitted. The state of charge of the battery
is too low to allow a complete op-
erating cycle.
▶
Change the battery and charge
the empty battery.
Red LED => lights briefly and
no warning tone is emitted. Product overheated. ▶ Allow the product to cool down.
9.2 The crimping / pressing tool is in working order.
Trouble or fault Possible cause Action to be taken
The battery runs down more
quickly than usual. Very low ambient temperature. ▶ Allow the battery to warm up
slowly to room temperature.
The battery does not engage
with an audible double click. The retaining lugs on the battery
are dirty.
▶
Clean the retaining lugs and refit
the battery.
Red LED => blinks at long
intervals and a warning tone
is emitted. Crimping / pressing pressure not
achieved (tool was used incorrect-
ly). ▶ Make sure that the tool is
used correctly and check the
crimping / pressing if unsure.
Red LED => lights continu-
ously and a warning tone is
emitted. Technical problem. ▶ Incorrect operation is possible!
Contact
Hilti Service.
Red LED => lights continu-
ously and no warning tone is
emitted. Product maintenance necessary. ▶ Contact Hilti Service.
10 Disposal
WARNING
Risk of injury due to incorrect disposal! Health hazards due to escaping gases or liquids.
▶ DO NOT send batteries through the mail!
▶ Cover the terminals with a non-conductive material (such as electrical tape) to prevent short circuiting.
▶ Dispose of your battery out of the reach of children.
▶
Dispose of the battery at your Hilti Store , or consult your local governmental garbage disposal or public
health and safety resources for disposal instructions.