Hilti DX462CM, Руководство по эксплуатации

Страница: 24 / 108

18
en
onto a hard surface, no matter at which angle the impact
occurs.
The trigger safety device ensures that the cartridge
cannot be fired simply by pulling the trigger only. The
tool can be fired only when pressed against the work
surface.
The contact pressure safety device requires the tool
to be pressed against the work surface with a signifi-
cant force. The tool can be fired only when pressed ful-
ly against the work surface in this way.
In addition, all Hilti DX tools are equipped with an unin-
tentional firing safety device
. This prevents the tool
from firing if the trigger is pulled and the tool then pressed
against the work surface. The tool can be fired only when
it is first pressed (1.) against the work surface correct-
ly and the trigger then pulled (2.).
5
4
3
1
2
4 2
5 3
4. Cartridges, accessories and characters
Marking heads
Ordering designation Application
X-462 CM Polyurethane head for marking up to 50°C
X-462 HM Steel head for marking up to 800°C
Pistons
Ordering designation Application
X-462 PM Standard piston for marking applications
Accessories
Ordering designation Application
X-PT 460 Also known as the pole tool. An extension system that allow marking on very hot
materials at a safe distance. Used with DX 462HM
Spares pack HM1 To replace the screws and the O ring. Only with X 462HM marking head
Centering devices For marking on curve surfaces. Only with X-462CM marking head. (Axle A40-CML
always required when centering device is used)
Characters
Ordering designation Application
X-MC-S characters Sharp characters cut into the surface of the base material to form an impression.
They can be used where the influence of marking on the base material is non-critical
X-MC-LS characters For use in more sensitive applications. With a rounded radius, low-stress characters
deform, rather than cut, the surface of the base material. In this way, their influence
on it is reduced