Hilti DSW 1510-CA, Руководство пользователя

Страница: 11 / 48

*2238935*
2238935 English 7
▶
Maintain power tools and accessories. Check for misalignment or binding of
moving parts, breakage of parts and any other condition that may affect the
power tool’s operation. If damaged, have the power tool repaired before use.
Many accidents are caused by poorly maintained power tools.
▶
Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are easier to control.
▶
Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for operations different from those intended could
result in a hazardous situation.
▶
Keep handles and grasping surfaces dry, clean and free from oil and grease.
Slippery handles and grasping surfaces do not allow for safe handling and control of
the tool in unexpected situations.
2.2 Proper arrangement of the workplace
▶
Approval must be obtained from the site engineer or site management before beginning
drilling and sawing work. Drilling and sawing work on buildings and other structures
can influence the statics, especially when steel reinforcing bars and load-bearing
components are cut through.
▶
Jointly with site management, make sure that no gas, water, electricity or other lines
are located in the cutting area. Use existing drawings and, for example, a detector
for this purpose. External metal parts on the device can become live, for example if
you inadvertently damage electric wiring. Lines in the vicinity of the cutting zone that
could be damaged by falling parts, for example, have to be specially protected and, if
necessary, temporarily taken out of service.
▶
Ensure that good lighting is in use.
▶
Make sure that the workplace is well ventilated. Poorly ventilated workplaces can
result in damage to health because of exposure to dust.
▶
Keep the workplace tidy. Objects which could cause injury should be removed from
the working area. Untidiness at the workplace can lead to accidents.
▶
In order to avoid injuries and to prevent the diamond wire becoming trapped and
stuck, steel wedges and/or supports must be used to prevent movement of objects
that are being cut free.
▶
Ensure that adequately-sized supports are correctly installed so that the remaining
structure maintains its stability after completion of the cutting work and removal of the
part cut away.
▶
Never loiter in areas where loads are suspended by crane or lifting equipment.
▶
The area of the cut or the opening created by the cutting process must be safely and
visibly cordoned off in order to avoid the risk of persons falling.
▶
Wear personal protective equipment. Wear safety footwear, protective gloves, a hard
hat and protective glasses.
▶
Dust from materials such as paint containing lead, some types of wood, minerals and
metal can be harmful to health. Contact with or inhalation of the dust can cause allergic
reactions and/or respiratory or other diseases to the operator or bystanders. Certain
kinds of dust such as oakwood and beechwood dust are classified as carcinogenic,
especially in conjunction with additives for wood conditioning (chromate, wood
preservative). Only specialists are permitted to work on material containing asbestos.
Use a dust-extraction device wherever possible. To achieve a high level of dust
extraction, use a suitable vacuum extractor of a type that is recommended by Hilti for
wood dust and/or mineral dust and which is designed for use with this power tool.
Make sure that the workplace is well ventilated. It is advisable to wear a filter class P2