2.4 Diagnostic interface
This interface at connector X4 facilitates the connection of a PC to the protocol
converter. It conforms to the RS232C standard to CCITT or DIN. Only the
necessary signals are provided.
The control signals are produced and evaluated as follows:
RTS is switched to high on readiness for operation and not changed.
CTS must be connected internal with Pin 4 and 8 of D-Sub connector
A 9-way D-Sub connector to DIN 41652 is used.
Data transfer between the PC and the protocol converter takes place at 9600 Baud
and uses the following data format: 8 data bits, 1 stop bit and even parity. The
3964R protocol is used as the transfer protocol.
The PC is connected by a three-way cable which must not be longer than 15 m.
The wiring of the cable is shown below.
Diagnostic cable between the protocol converter and the PC
General device description
11
Copyright * Hilscher Gesellschaft für Systemautomation mbH * Hotline/Support: +49 (0) 6190/9907-99 * De:P30IBS#3E
