8
Operation
Maintenance Advice
Over a period of time some chemicals can leave
a build up of residue which normal cleaning will
not remove. This build up can collect around
the seals in your sprayer, which may eventually
stop the sprayer from working. To overcome
this problem we recommend that the bottle be
half filled with hot (not boiling) water. Pressurise
and spray for a few minutes. The hot water
should dissolve any built up residue allowing
your sprayer to operate normally. Thoroughly
dry after cleaning.
Apply a small coating of silicone grease regularly
to seals and moving parts.
Important:
For safety, do not leave the sprayer
unattended during this operation.
Fig. 1
Fig. 2
Fig. 3
Fig. 4
Fig. 5
Strip Spray
Your sprayer comes with an additional jet spray
nozzle attachment to aid in controlled spraying.
• To fit strip spray, remove the blue nozzle
from the grey attachment cap.
Refer to
Fig. 1 and 2
.
• Remove the nozzle from cap. Refer to
Fig. 3
.
• Re-assemble the two blue halves of nozzle
and store safely.
• Place jet spray nozzle into rear of attachment
cap along with filter.
Refer to
Fig. 4
.
• Replace assembly onto end of nozzle elbow.
Refer to
Fig. 5
.
455644_HH2359_5L_8L_Heavy_Duty_Manual.indd 8
29/10/2015 3:43 pm
