41
7.3.1
Configuring
Basic
PTZ
Settings
Settings for a PTZ camera must be configured before it can be used. Before proceeding,verify that the PTZ and RS-485 of the
DVR are connected properly.
To configure PTZ settings:
1.
Enter the PTZ Configuration menu, shown in Figure 42 by going to MainMenu > System Configuration > PTZ
Configuration.
Figure 42. PTZ Configuration Menu
2.
Select the
Serial Settings
tab.
3.
Select the camera to configure in the camera drop down menu on the upperleft of the menu. If all cameras are to be
configured with the same settings,select
All Cameras
from the list
.
4.
Configure PTZ settings, including those of
Baud Rate
,
Data Bit
,
Stop Bit
,
Parity
,
Flow Ctrl
,
Protocol
and
Address
according to the parameters of the PTZcamera(s).
5.
Click the Save button to save current settings.
To test and verify PTZ settings:
1.
Enter the PTZ Configuration menu, shown in Figure 41 by going to MainMenu > System Configuration > PTZ
Configuration.
2.
Select the
On Camera Settings
tab. This will open up the On Camera Settingsmenu, shown in Figure 43.
Figure 43. PTZ Configuration
Содержание DS-7200HVI-ST Series
Страница 1: ...1 DS 7200HVI ST Series DVR USER S MANUAL Version 1 0 ...
Страница 7: ...7 C H A P T E R 1 Introduction ...
