27
3.
Select the
Encoding Parameters
mode to configure. Either Continuous or OnEvent can be selected.
4.
Select the camera resolution in the
Resolution
drop down menu The optionsfor the camera resolution includes
4CIF,CIF and QCIF.
5.
Select the recording
Frame Rate
to use for the designated camera. A rate of25 all the way down to 1of a frame can be
selected.
6.
Set the picture quality using the
Picture Quality
slider. A preview of theselected picture quality will be shown on the
right preview screen. Increasingthe picture quality will also increase the bit rate of the video feed. The resolutionand
frame rate of the feed will be adjusted automatically.
7.
Select the
Pre-record
time. The pre-record time is the time in seconds to alsorecord before a recording is triggered.
Setting the pre-record time to MAX willallow the DVR to use up to the maximum available buffer space for recording.
8.
Select the
Post-record
time. The post-record time is the time in seconds toalso record after a recording has ended.
9.
Enter the
Files Removed After
time. The
Files Removed After
time denotesthe amount of days that files will be
deleted after its initial recording. Settingthe time to 0 will allow the DVR to only delete and overwrite files when
theHDD is full.
10.
Repeat steps 3-9 for other Encoding Parameters mode.
11.
Select the Save button to save the recording quality settings and select Exit toreturn to the previous menu. Selecting the
Exit button without clicking Savewill quit out of the menu without saving settings.
Note
:
For 7204HVI‐ST Series,
when resolution is 4CIF,Frame rate can be set as 12 all the way down to 1. For 7208HVI-ST
Series, when resolution is 4CIF, Frame rate can be set as 8 all the way down to 1,But for 7216HVI-ST Series, when resolution is
4CIF, Frame rate can only be set as 6 all the way down to 1.
4.1.2
Configuring
a
Quick
Recording
Schedule
A quick recording schedule allows you to set one time period per day for recording.
To setup a quick recording schedule:
1.
Enter the Quick Schedule Configuration menu, shown in Figure 25 by going toMain Menu > Recording
Configuration > Quick Schedule Configuration.
Figure 25. Quick Schedule Configuration Menu
2.
Select the camera to configure from the camera drop down menu. If all thecameras are to be configured with the
same settings, select
All Cameras
fromthe list.
3.
Check the
Enable
checkbox to enable the recording schedule. If the checkboxis unchecked, the recording
schedule will be disabled.
4.
Check the
24/7
checkbox if you would like to record continuously or on eventfor 24 hours a day, 7 days a week. If
you wish to schedule different time framesfor Monday through Sunday, leave the
24/7
checkbox unchecked and
skip tostep 6.
5.
Select
Recording Type
for 24/7 recording and move on to step 8. Recordingtype includes
Continuous
for
continuous recording or
On Event
for recordingwhen an event is triggered (i.e. from detected motion).
6.
Select the start and stop time for each day of the week. The start and stop timeare listed using a 24 hr cycle (i.e.
18:00 is equivalent to 6:00pm).
7.
Select
Recording Type
for each day of the week. Recording type includes
Continuous
for continuous recording or
On Event
for recording when an eventis triggered (i.e. from detected motion) for the selected time period.
Содержание DS-7200HVI-ST Series
Страница 1: ...1 DS 7200HVI ST Series DVR USER S MANUAL Version 1 0 ...
Страница 7: ...7 C H A P T E R 1 Introduction ...
