Hikoneb 908 DC, Руководство пользователя

Страница: 6 / 50

H i k o n e b | 9 0 8 D C
6
User Manual
•Do not use this product with a DC to AC converter, or with any AC voltage and/or
frequency other than specified.
•The Hikoneb 908 complies with EMC requirements conforming to IEC:60601-1-2.
Nevertheless, location should be considered with caution, when this product is used in
the vicinity of other electronic equipment where electromagnetic interference may be
an issue.
•Make sure that all parts are connected correctly, and that the dust filter is clean. A filter
which has changed its colour or used a period of 3 months, should be replaced.
•Bacteria filter should be replaced every 48 hours, in between patients and when it gets
dirty.
NOTE
•Dispose of any remaining medicines. Do not use again.
•Medicine cups are for single use only.
•Use original parts and accessories only.
•The device has been designed for inhalation using a mouthpiece or a face mask.
When only using the aerosol tube (for humidification purposes), there should be at least
10cm distance between a patient and the tube.
•Room/ambient temperature should not exceed 30°C when used with the heater
system.
•Only medical clean/sterile water should be used for nebulization. Medicines can be
nebulized as aqueous solution only.
•The nebulizer chamber is equipped with a maximum and minimum water level mark.
Water should be filled into the chamber between these two marks. If a sterile water
bottle is used, the gasket should be placed completely on the bottle lid, to prevent
flowing water from the chamber. In addition, make sure that the lid is tightly secured on
the sterile water bottle. After each use, this system should be cleaned, disinfected and
sterilized.
•The device should be used with original manufacturers air filter.
•Caution should be taken when removing the chamber, tubing/tube heater after
therapy, as these items may be very warm.
•Only authorized service personnel are allowed to open the device to conduct
troubleshooting and failure analysis. Do not try to open or repair the device by yourself.