English
35
3. Changing
bit
WARNING
Prevent inadvertent starting: Set manual mode and remove battery from the tool
before performing any retooling.
Inserting and removing the bit (
Fig. 9
)
– Remove the stopper.
–
Insert
: Insert the bit in the magnetic bit holder.
–
Remove
: Pull the bit from the magnetic bit holder using pliers.
– Attach the stopper again: turn and engage in position when mounted.
NOTE
The magnetic bit holder may be removed from the spindle if the sleeve is pulled back.
Fig. 9
Stopper
Bit
Spindle
Magnetic bit holder
Closure sleeve
4. Working with stopper
(Fig. 10
)
The depth of screw can be set by turning the setting sleeve. On rotation of the knurled
screw corresponds to a drill depth of around 1.5 mm.
Adjust the setting sleeve so that the screw head is approx. 2 mm outside the stop sleeve
when applying the screw.
Insert a screw as a test. Correct the screw depth if necessary.
CAUTION
When screwing in crosshead screws, press the machine with the bit
fi
rmly against
the screw until the screw is fully inserted; otherwise the bit could slip out of the
cross recess and damage the material.
1/6" (2 mm)
Stop sleeve
Setting sleeve
1/6" (2 mm)
Union sleeve
Fig. 10
000Book̲W18DA̲ChS.indb 35
000Book̲W18DA̲ChS.indb 35
2022/03/16 15:47:12
2022/03/16 15:47:12
