English
34
HOW TO USE
Installation of hook
The hook may be screwed into place on the left or the right (see
Fig. 4 on page 29
).
USE
1. Setting the direction of rotation, engaging the transporting safety device (switch-on lock)
CAUTION
Only activate the rotation selector switch when the motor has completely stopped.
See
Fig. 4 on page 29
R
= Clockwise setting
L
= Anti-clockwise setting
0
= Centre position: with the transporting safety device engaged (switch-on lock)
2. Selection operating mode, switch on / o
ff
Set the required operating mode on the dial. (see
Fig. 4 on page 29
).
NOTE
When the motor is running, the spindle does not start until the spindle is pushed in.
Manual mode
Switch on: press the trigger switch. Press in the trigger to increase the rotational speed.
To switch o
ff
release the trigger switch.
Automatic mode
The tool starts automatically when the spindle is pushed in. This facilitates convenient
work. In order to enable automatic mode, brie
fl
y press the trigger switch.
NOTE
The tool switches to sleep mode after 15 minutes without use. To activate again: press the
trigger switch brie
fl
y.
WARNING
Risk of injury from inadvertent automatic machine start-up. In automatic mode, do
not touch any rotating parts such as spindle, bit or magnetic bit holder.
Impulse mode
Protruding screws can be precisely countersunk using this function. Press trigger switch and
countersink the screw with the attached stopper. To switch o
ff
release the trigger switch.
NOTE
○
If the amount of protrusion of the screw is small, the screw may not tighten.
○
In that case, remove the stopper and make adjustments in Manual mode.
000Book̲W18DA̲ChS.indb 34
000Book̲W18DA̲ChS.indb 34
2022/03/16 15:47:11
2022/03/16 15:47:11
