-5-
• Mounting the blade ass’y, cam rod holder, and cam rod
(6) Apply grease (Nippeco SEP-3A) to the tooth surface on the Gear
[41]
, sliding portion on the Cam Rod
[40]
, and the cam. Put the Washer
[39]
on the Ball Bearing 608DD
[38]
, and insert the shaft of the
Gear
[41]
into the Ball Bearing 608DD
[38]
. Check that the Cam Rod
[40]
engages with the cam of the
Gear
[41]
.
(7) Apply grease (Nippeco SEP-3A) to both sides of the Cam Rod
[40]
(on the bottom cover side), inner
diameter of the cam mounting hole, and blade pin mounting hole. Then fit the blade pin and cam of the
Gear
[41]
in the Cam Rod
[40]
. Fit the Washer
[39]
onto the shaft of the Gear
[41]
.
NOTE: Mount the Cam Rod [40] with its shear droop surface facing toward the Gear [41] (on the
blade side).
(8) Slide the Cam Rod Holder
[45]
toward the Gear
[41]
so that the upper and lower blades are
sandwiched between the two Cam Rods
[40]
in the Cam Rod Holder
[45]
.
[39]
[45]
[43]
[40]
Sandwich the upper and
lower blades between the
two Cam Rods
[40]
in the
Cam Rod Holder
[45]
.
