-3-
• Mounting spring (E)
• Wiring diagram
[21]
[20]
Switch 1
[11]
[25]
[26]
LED circuit board
[23]
[24]
A
(2) Pay attention to the soldering direction when soldering the internal wires of the two Switches
[11]
.
(3) Pay attention to the polarity of the Diode
[21]
when mounting it.
(4) Pay attention to the soldering direction when soldering the internal wires of the Controller Ass’y
[23]
to
two Switches
[11]
and Battery Terminal
[26]
.
(5) Mount the Motor DC 36 V
[20]
and the assembly of the Controller Ass’y
[23]
, two Switches
[11]
, and
Battery Terminal
[26]
to housing (A) of Housing (A).(B) Set
[27]
aligning the concave portions of the
Motor DC 36 V
[20]
with the convex portions of housing (A).
(6) Mount the Trigger
[25]
, Spring (E)
[24]
, Push Pin
[17]
, Spring (D)
[12]
, and Battery Rubber (B)
[29]
to
the specified positions in Housing (A).(B) Set
[27]
.
NOTE: Mount Spring (E) [24] at a right angle to the Switch [11]. Check that Spring (E) [24] is not
bent, misaligned, or dropped.
Switch 1
[11]
[25]
[24]
[8]
Switch 2
[11]
A
