HIKOKI CC 14STA, Инструкция по эксплуатации, Страница: 7 / 60

English
7
◯
When a large work-piece should be processed, move the auxiliary stopper forward 35 mm
(see Figure 4 ).
◯
Raise the section bar with a supporting block, if you want to continuously use a worn abrasive
wheel. Check the size of the supporting block fi rst. Ensure that it is smaller than the size of the
section bar, so that the section bar can be secured by the vice (see Figure 5 ).
Figure 4 Figure 5
Supporting block
CLEANING AND MAINTENANCE
1. Keep the motor-outlet well ventilated and clean. Compressed air can be used to blow o ff the
dust in motor.
2. Check the bearing housing and the gearbox periodically and lubricate them occasionally.
3. After the cutting-o ff machine has been operated for 40 hours, check the carbon brush for
replacement. The carbon brush should be changed, when its length is shortened to only 5-6
mm by abrasion (see Figure 6 ).
Figure 6
5
Figure 7
4. Remove the brush lid with a screwdriver for checking and replacing the brush. Take away the
worn brushes, and insert a new pair. Let the motor run idle for 10 minutes (see Figure 7 )
000Book_CC14STA_1.indb 7 000Book_CC14STA_1.indb 7 2018/7/25 16:14:53 2018/7/25 16:14:53