HIKOKI CC 14STA, Инструкция по эксплуатации

Страница: 5 / 60

English
5
2. The main data of the abrasive wheel should accord with the demands in the Table 1:
Type Outer Diameter Inner Diameter Thickness
Operating Linear Velocity
of the Abrasive Wheel
CC14STA 355 25.4 2.8 80 m/s
3. Use only abrasive wheels in good conditions. Knock the wheel with a beetle, crack or other
abnormal noise should not be heard.
4. An abrasive wheel that has been stored for more than one year should be performed
strength test. It can be only used after passed the test.
5. Before carrying out any work, allow the motor to run idle for one minute. Make sure there is
no oscillation caused by improper installing of the abrasive wheel. Unusual oscillation may
cause the breach of the wheel and the installation should be adjusted.
6. Secure the work-piece properly with vice before start cutting. Adjust the feeding speed of the
wheel according to the pro fi les, materials and the diameter of the section bar.
7. Replacing abrasive wheel
◯
The abrasive wheel should be changed when 1/3 of the outer diameter is worn out.
◯
Unplug the machine before changing the wheel.
Make sure the cutting-o ff machine stopping completely before changing the wheel.
Disassembling the abrasive wheel
To open the side-cover, press the bolt behind the guard. Using the provided socket wrench to
remove the hexagon bolt which fi x the guard and side-cover. Then remove the washer, the outer-
fl ange, the shield ring, the abrasive wheel and the inner- fl ange in order (see Figure 1 ).
Installing the abrasive wheel
Wipe away the dust from the spindle and the dismounted parts, then install all parts including a
new wheel in reverse order as above.
1. guard
2. spindle
3. inner- fl ange
4. abrasive wheel
5. outer- fl ange
6. side-cover
7. hexagon bolt
8. Adjustment of the vice
The auxiliary stopper of the vice can be tilted to an
angle of –30° to 45°.
Figure 1
000Book_CC14STA_1.indb 5 000Book_CC14STA_1.indb 5 2018/7/25 16:14:52 2018/7/25 16:14:52