HightPoint Technologies RocketStor 6314A, Руководство пользователя

Страница: 45 / 61

45
System Settings
Enable auto rebuild (default: Enabled)
When a physical drive fails, the controller will take the drive offline. Once you re-insert or
replace the disk, the controller will not automatically rebuild the array unless this option is
enabled.
Enable continue rebuilding on error (default: Enabled)
When enabled, the rebuilding process will ignore bad disk sectors and continue rebuilding until
completion. When rebuild is finished, the data may be accessible but data inconsistency due to
ignored bad sectors may cause problems in the future. If this option is enabled, HighPoint
recommends user to check the event log for bad sectors.
Enable audible alarm (default: Enabled)
When a physical disk fails, the controller will emit an audible sound signaling failure. This
option mutes the alarm.
Set Spin down Idle Disk (minutes) (default: Disabled)
When set, physical drives will spin down a certain amount of time after disk activity ceases.
Only 10, 20, 30, 60, 120, 180, 240 minutes setting are available.
Restrict to localhost access (default: Enabled)
Remote access to the controller will be restricted when enabled , other users in your network
will be unable to remotely log in to the WebGUI.
Rebuild Priority (default: Medium)
You can specify the amount of system resources you want to dedicate to rebuilding the array.
There are 5 levels of priority [Lowest, Low, Medium, High, Highest]
Port Number (default: 7402)
The default port that the HighPoint WebGUI listens on is 7402. You may change it to any open
port.
Password Setting