RocketRAID 152x Driver and Software Installation
2.
In the popup window, select Hardware tab and then click Device Manager
button.
3.
Double click the “SCSI and RAID controllers” entry. If the RocketRAID 152x
device entry is not displayed, or there are “?” or “!” marks displayed near the
RocketRAID 152x entry, the driver has not been installed properly. Delete the
entries and reinstall the driver.
Installing the RocketRAID 152x driver during a fresh Windows
2000/XP/2003/x64/Vista installation
1.
After booting from the Windows 2000/XP/2003/Vista CD-ROM, when the Win-
dows Setup blue screen appears, look towards the bottom of the screen. Win-
dows will prompt you to press the F6 key if you want to install a third party SCSI
or RAID driver. Press the F6 key at this time.
2.
The setup procedure will continue, and will later instruct you to press the “S” key
to specify additional adapters. Press the “S” key as instructed.
3.
Next, the setup program will prompt for the insertion of the driver diskette. Please
insert the driver diskette, and then press ENTER to continue.
4.
The next window will display several driver options. Please select the
RocketRAID 152x Controller for the corresponding operating system, and press
ENTER to continue.
1 - Installing the RAID Management Console/ Interface
Overview
To install the RAID software, locate the setup.exe file located on the floppy diskette
labeled “DISK 1” (or the Disk1 folder, if the software was downloaded). Double click
this file to start the Installation Wizard.
Note: If the system chassis supports SAF-TE, make sure to select the corresponding
chassis-type/manufacturer when prompted.
There is no need to restart the system after installing the software. To start the
software, click on the “Start” button, select “Programs”, and click on the “HPT
Management Console.”
4-4
