Highlight Predator SS, Руководство по эксплуатации

Страница: 16 / 67

Installation & Adjustments Predator SS Turntable Stretch Wrapper Operation Manual
Highlight Industries, Inc. ● 2694 Prairie S W, Wyoming , Mi 49519 ● 1 -800-531-2465 15
Unpacking and Moving the Machine
It is very important to read all instructions before undertaking any of these steps. The
following steps should help achieving a safe and quick machine set-up.
1. Place the skidded machine close to the designated wrap area. Remove all shipping
fasteners holding the machine to the pallet. The machine may be crated with the
tower tilted down with the motor cover and carriage removed for shipping purposes.
1.1. Stand up tower, pivoting about the pivot bracket at the base of the tower. Once
upright align 5 bolts at tower base to frame and tighten.
1.2. Remove 4 lower bolts from carriage mount bracket – leave the top 2 bolts loose but
in place. Align keyholes on carriage back over top 2 bolts in carriage mount bracket
and hang carriage. Install and tighten all 6 mounting bolts.
1.3. The carriage photo eye bracket may need to be unbolted from its shipping position
(Figure 3) to its operating position (Figure 4).
1.4. Mount motor cover in place over turntable and carriage lift motors with provided
fasteners.
1.5. Re-connect wiring to carriage if removed for shipping.
2. Place the forks of the forklift through the tubes provided on the base of the machine,
remove the machine from the shipping skids, and place it in the designated wrap
area.
3. If the OPTIONAL ramp (Part Number #600086) is purchased:
Select a ramp position as illustrated below. The ramp can be positioned anywhere in
a 180° rotation around the front of the turntable. There should be ¼
” gap between
the turntable and the ramp. The ramp should be fully supported by the floor. Both the
ramp and the machine should be lagged to the floor.
Machine Set-Up