Highlight Predator SS, Руководство по эксплуатации

Страница: 30 / 67

Operation Instructions Predator SS Turntable Stretch Wrapper Operation Manual
Highlight Industries, Inc. ● 2694 Prairie S W, Wyoming , Mi 49519 ● 1 -800-531-2465 29
Normal System Start-Up
After the machine has been positioned and supplied with proper voltage, you are ready to
begin operating. Read thoroughly and follow these steps to operate your system:
1. Place product on the turntable
2. Make sure the film carriage is situated at the max down position.
3. Thread the film as instructed, and attach it to the product.
4. Set the desired number for top and bottom wrap counts.
5. Select wrapping made “A”, “B”, or “C”.
6. Press the “Start button to initiate cycle.
Stop Condition
Follow the procedure below in the event of an emergency.
1. Press the “STOP” button. This cancels the current wrapping cycle and immediately
stops the system.
2. Correct the problem.
3. Pull the “STOP” button out, and then perform normal system start-up procedure.
Note
After pressing the “E - STOP” button, wait for at least 60 (sixty) seconds before
pulling the button back out. This will allow the microcontroller card to completely
turn off.
Applying Reinforcement Wraps
Automatic operation can be paused in order to apply reinforcement wraps to an additional
top sheet or corner boards on the product. Follow he procedure below.
1. Press the “START” button as normal to initiate cycle.
2. As the carriage
travels up, press the “Banding” button. The carriage will stop and
reinforcing wraps will be applied.
3. Letting go of the “Banding” button will resume the cycle.
Machine Operating Instructions