HIGHLEAD DY-850, Инструкция по эксплуатации

Страница: 17 / 46

— —
15
(C) aligns with the lower edge of Reference Hole (G) of feed and feed lifting eccentric. Leave a clearance of
0.3-0.5mm between Feed and Feed Lifting Eccentric ( B ) and Eccentric Sleeve ( H ), then tighten Set Screws
( A ) and ( D ).
19.剪线装置的调整
ADJUSTMENT OF THREAD TRIMMER MECHANISM
1）剪线装置如图所示
The thread trimmer mechanism illustrated
2)
剪线电磁铁的行程：
Operation stroke of the thread trimmer solenoid
：
(1)
标准的行程为
6.0m
。
(2)
通过调节螺母
A
来调整行程。
(1) Standard operation stroke is 6.0mm.
(2) This stroke can be adjusted by using nut “A”.