Item:
Description:
5801200
2-Bike Carrier
TOOLS REQUIRED:
Socket Wrench
17mm Socket
1-1/4” to 2” Shank Adapter Insert Instructions
1
3
2
5
4
ADAPTER ALLOWS THE USE
OF 1-1/4” ACCESSORIES TO BE
USED IN 2” RECEIVERS.
DO NOT USE FOR TOWING.
FIGURE 8
CLAMPED POSITION
FIGURE 7
1
Qty. (2)
Angle Bracket
4
Qty. (1)
Flat Washer, 7/16
2
Qty. (1)
Socket Cap Screw, 10mm x 70mm CL8.8
5
Qty. (1)
Hexagon Key Wrench, 8mm
3
Qty. (1)
Hex Lock Nut, M10 x 1.50
IMPORTANT NOTES:
•
Save hexagon key wrench and keep in a safe place.
•
Periodically check and re-tighten bolts.
1.
PLACE ANGLES AROUND SHANK, ALIGN HOLES IN ANGLES WITH HOLE IN SHANK, AS SHOWN.
2.
HOLD SHANK AND ANGLES FIRMLY TOGETHER AND INSERT INTO RECEIVER. ALIGN HOLES IN
ANGLES AND SHANK WITH HOLES IN RECEIVER.
3.
INSERT SOCKET HEAD CAP SCREW THROUGH RECEIVER, ANGLES AND SHANK SO THAT HEAD OF
SCREW IS RECESSED IN DRAWBAR PIN HOLE ON RECEIVER AS SHOWN IN FIGURE 8.
(SCREW MAY BE INSTALLED FROM EITHER SIDE OF RECEIVER)
4.
ASSEMBLE FLAT WASHER AND LOCKNUT ONTO SCREW. TIGHTEN NUT WITH SOCKET WRENCH
WHILE HOLDING SCREW WITH HEXAGON KEY. TIGHTEN SECURELY ENOUGH TO REMOVE ALL PLAY
AS SHOWN IN FIGURE 8.
FREELY ON SOCKET HEAD CAP SCREW.
REPLACE WITH NUT OF SAME TYPE IF NYLON INSERT BECOMES WORN OR NUT TURNS
DO NOT USE FOR TOWING.
WARNING
