Warming up engine
Manual start models
1. After starting the engine, return the choke knob to the halfway position. For approximately the
first 5 minutes after starting, warm up the engine by operating at one fifth throttle or less. After
the engine has warmed up, push the choke knob in fully. Failure to do so will shorten engine
life.
NOTE
• If the choke knob is left pulled out after the engine starts, the engine will stall.
• In temperatures of -5°C or less, leave the choke knob pulled out fully for approximately 30
seconds after starting.
2. Check for a steady flow of water from the cooling water pilot hole.
CAUTION
A continuous flow of water from the cooling water pilot hole shows that the water pump is
pumping water through the cooling passages. If water is not flowing out of the hole at all times
while the engine is running, overheating and serious damage could occur. Stop the engine and
check whether the cooling water inlet on the lower case or the cooling water pilot hole is blocked.
Consult your dealer if the problem cannot be located and corrected.
Shifting
WARNING
Before shifting, make sure there are no swimmers or obstacles in the water near you.
NOTE:
To change the boat direction or shifting position from forward to reverse or viceversa, first close
the throttle so that the engine idles (or runs at low speeds).
20
