HID FARGO DTC 5500LMX, Руководство пользователя

Страница: 64 / 74

Troubleshooting Page 5-10
PLT-02496, Version: 1.2 May 2017
#356
Laminator General
Error
The Laminator has reported a
general fault.
Ensure that the laminate material is properly installed. Clear
any cards in the Laminator Module by using the manual feed
on the Laminator. Press the Resume button to continue. To
cancel, press the Cancel Print button or the Cancel button
located on the Printer.
#357
Laminator General
Error
The Laminator has reported a
general fault.
Ensure that the laminate material is properly installed. Clear
any cards in the Laminator Module by using the manual feed
on the Laminator. Press the Resume button to continue. To
cancel, press the Cancel Print button or the Cancel button
located on the Printer.
#358
LAM1 Laminate
Not At TOF
The Laminator has reported a
general fault.
Ensure that the laminate material is properly installed. Clear
any cards in the Laminator Module by using the manual feed
on the Laminator. Press the Resume button to continue. To
cancel, press the Cancel Print button or the Cancel button
located on the Printer.
#359
LAM2 Laminate
Not At TOF
The Laminator has reported a
general fault.
Ensure that the laminate material is properly installed. Clear
any cards in the Laminator Module by using the manual feed
on the Laminator. Press the Resume button to continue. To
cancel, press the Cancel Print button or the Cancel button
located on the Printer.
#360
LAM1 Laminate
Not Ready
The Laminator has reported a
general fault.
Ensure that the laminate material is properly installed. Clear
any cards in the Laminator Module by using the manual feed
on the Laminator. Press the Resume button to continue. To
cancel, press the Cancel Print button or the Cancel button
located on the Printer.
#361
LAM2 Laminate
Not Ready
The Laminator has reported a
general fault.
Ensure that the laminate material is properly installed. Clear
any cards in the Laminator Module by using the manual feed
on the Laminator. Press the Resume button to continue. To
cancel, press the Cancel Print button or the Cancel button
located on the Printer.
#362
Laminator General
Error
The Laminator has reported a
general fault. Cycle power to system. If the error persists, contact Technical
Support.
#363
Laminator
Calibration Error
The Laminator is unable to
calibrate the LAM1 laminate load
sensor.
Ensure that the LAM1 laminate material is properly installed
and covering the LAM1 laminate sensors. Clear any cards in
the Laminator. Press the Resume button to continue. If the
error persists contact, Technical Support.
#364
Laminator
Calibration Error
The Laminator is unable to
calibrate the LAM2 laminate load
sensor.
Ensure that the LAM2 laminate material is properly installed
and covering the LAM2 laminate sensors. Clear any cards in
the Laminator. Press the Resume button to continue. If the
error persists, contact Technical Support.
#365
Laminator
Calibration Error
The Laminator is unable to
calibrate the LAM1 laminate
position sensor.
Ensure that the LAM1 laminate material is properly installed
and covering the LAM1 laminate sensors. Clear any cards in
the Laminator. Press the Resume button to continue. If the
error persists, contact Technical Support.
#366
Laminator
Calibration Error
The Laminator is unable to
calibrate the LAM2 laminate
position sensor.
Ensure that the LAM2 laminate material is properly installed
and covering the LAM2 laminate sensors. Clear any cards in
the Laminator. Press the Resume button to continue. If the
error persists, contact Technical Support.
Error Message Cause Solution