OPERATING INSTRUCTIONS:
Electric Torque Wrench
Series: TWE
TDS:-
1399
Prepared by:- M.DAVIES
Approved by:-
Date: 25/03/14
REV NO:-
1
ECO:-
Page
10
of
20
3.1.5 RIGHT / LEFT SWITCH
The direction of rotation of the tool is
permanently indicated by the LED
(3)
when tool
is switched on.
Push the right/left button to switch rotation
direction, the tool will also emitting a short
sound signal during this operation.
3.1.6 GEAR SETTING
The wrench is calibrated in 1st and 2nd gear mode, therefore choose the respective gear according to the
required selected torque.
1st gear: control knob
(9)
in position 1
2nd gear: control knob
(9)
in position 2
Only change gear when the motor is NOT running.
Should the speed selector not engage properly, operate the torque wrench for a short time with no load
applied.
3.1.7 FAST / SLOW MODE
By pressing the <Select> button the operator can
switch between FAST
u
and STRONG Mode.
By pressing <Select> the chosen selection will
flash three times.
Display: Strong = Str, Fast = Fst
In STRONG Mode the tool operates with less
speed and switches off automatically.
The operator must work in the SLOW/STRONG
Mode, if the bolt is 20% longer than that laid
down in the factory calibration certificate.
In FAST Mode
u
the tool works with higher
speed.
The operator can work in the FAST Mode
u
, if
the bolt is the same length as the value laid
down in the factory calibration certificate.
