HFM 10015300, Руководство по эксплуатации

Страница: 9 / 28

9
IMPORTANT!
Risk of damage!
• It is imperative that you ride your scooter with caution in order to avoid
endangering/injuring/damaging yourself or third parties and objects.
• Do not use the electric scooter in adverse weather conditions and only use it on
surfaces that are as even, dry and clean as possible.
• Dismount on steep slopes.
• In case of strong winds, rain and frost, make sure that you have a suitable
protected parking place.
• If you put a cover over your scooter, park it in a sheltered place because the
cover can easily be caught by the wind.
• Never exceed the maximum load.
• Never stand on the rear mudguard (fender).
• Do not ride over kerbs or similar, as the battery compartment and the licence
plate holder may hit the ground.
• Check that all screws are tight before setting off.
• It is imperative that you have repairs carried out by qualified mechanics.
Contact a specialist workshop for this purpose. In case of unauthorised
repairs/modifications to the vehicle, removal of original parts, improper
connection or incorrect use, all liability and warranty claims shall be excluded.
• Check the basic functions of the electric scooter before each trip (see "Before
riding your electric scooter"/"Before every trip"). Insufficient checks on the
vehicle can lead to accidents and serious damage/injury.
• At the end of the trip, switch off your electric scooter immediately to avoid
running down the battery unnecessarily.
• The electric scooter must be serviced regularly by a specialist workshop, i.e.
approximately every 200 km or after being recharged 15 times, in order to keep
it in a safe condition for use on public roads.
• Before each trip, the electric scooter must be checked for damage. The electric
scooter must not be ridden if damage is discovered.
• The use of non-original parts may invalidate the type approval, and the
distributor is not liable for any such parts. Only use parts and accessories
which have been approved by the distributor or manufacturer.
4 | Preparation/assembly
First remove the scooter, together with the foam padding, from the box. Carefully remove the foam
padding and fold down the side stand (1).
Then unfasten the handlebar locking mechanism on the rear mudguard (2) and pivot the steering
column
into its upright position (3). Then lock the steering column with the quick-release (4) and
secure it with the locking mechanism to prevent it from being opened unintentionally (5).
Connect the handlebar with stem to the steering column, and secure it with the 4 hexagon socket
screws (6), using the 3 mm hexagon key supplied. Max. tightening torque 3 Nm.