Heyner capsula MN3, Руководство пользователя

Страница: 12 / 35

-capsula.com c -capsula.com c
GB
English English
1.2.2. Height and length adjustment of the shoulder belts
Height adjustment of the harness belts (G2):
• The
capsula
®
MN
3
X / capsula
®
MN
3
consists of a seat part (ST) and a base part (BT),
which are connected by a safety bolt (SB).
fi g.2
• De-block the safety lock (SR) of the safety bolt at the rear side of the base part (BT) and
slide out the safety bolt (SB) sideward’s out of the base holes (BL). Now the seat part (ST)
is de-blocked and can be fl apped forward.
fi g.2a
• Release both belt ends of the harness belts (G2) from the belt anchorage (R) at the back
of the seat part (ST), and pull the belt ends out of the slots (G1).
• Then release the shoulder pad connector belts (SG) from the connecting hook (VH).
• Put that are appropriate to the child‘s size and thread them back into the belt
anchorage (R).
• Finally put the pad connector belts (SG) under the harness belt ends (G2) through the
same belt slots (G1) and hook them back into the connecting hook (VH).
fi g.2b
• To release the belts ( fi g.2b), push the belt adjuster (I), hidden by the cover, and pull both
harness belts (G2) simultaneously forward.
fi g.2c
• To shorten the shoulder belts, just pull the central harness belt (G5). Do not block the
shoulder belts during pulling.
fi g.2d
• Now fl ap back the seat part (ST). Slide back the safety bolt (SB) sideward’s into the
base holes (BL). Block the safety lock (SR) of the safety bolt at the rear side of the
base part (BT).
Attention:
The safety bolt (SB) shall has to be fi xed correctly to both seat part (ST) and base part
(BT) before the seat is placed into the car for installation.
Attention:
It is recommended to check the belt position very regularly and to adjust it to the size
of your growing child. The belts must lie fi rmly against the child‘s body and must not be
twisted.
Important:
• The belts must not be twisted or blocked. Please refer to the drawing. in case of any
doubt or contact your seller or dealer, importer or manufacturer.
1.3. Fixing with ISOFIX and Top Tether c
apsula
®
MN
3
X
1.3.1. Conditions
For fi xing with ISOFIX (I) and Top Tether (TT) there is a
“semi-universal“ approval. For this reason, these seats can only be used in certain cars.
The seat has to be used with the ISOFIX fastening system (I) and the Top Tether (TT).
Based on the list of types you know, in which cars and with which seats the
capsula
®
MN
3
X
can be used. The current version can be found on
c-capsula.com.
3 4