Configuration and Operation
LD8 Operations Manual
AB- V-MA-00635_RevA6
16
Where possible, different VERIPOS receiver units on the same vessel should be set to different beams to
maximise redundancy.
4.2.1 Selecting Beam Via WebUI
To select Auto Beam (or a single beam if required) navigate to
Configuration > Positioning
and click
Receive
(Rover)
, f ollowed by
Next
. On the next page expand the
PPP
section and select either Auto or an available
beam, f ollowed by
Apply
:
4.2.2 Selecting Auto Beam via Terminal
To enable the use of Auto Beam enter the following:
ASSIGNLBANDBEAM AUTO
4.2.3 Selecting a Single Beam via Terminal
The f ormat for assigning a specific L-band beam (98W, AORW, 25E, IOR, 143.5) is as follows:
ASSIGNLBANDBEAM BEAMNAME
4.2.4 Entering a Custom Beam Frequency via Terminal
A custom L-band beam name and frequency (in Hz) can be manually entered, however this should be used only
under the instruction of VERIPOS support. The f ormat for assigning a user L-band beam is as follows:
ASSIGNLBANDBEAM MANUAL BEAMNAME FREQUENCY 1200
