
Table 18 8/8, 8/24 and 8/40 SAN Switch memory
Install memory
Memory type
512 MB
Main Memory (SDRAM)
8/40 SAN Switch only: 4 MB
Boot Flash
1 GB
Compact Flash
lists the 8/80 SAN Switch, Encryption SAN Switch, and FCoE Converged
Network Switch memory specifications.
Table 19 8/80 SAN Switch, Encryption SAN Switch, and FCoE Converged Network Switch
memory
Install memory
Memory type
1 GB
Main Memory (DDR2 SDRAM)
4 MB
Boot Flash
1 GB
Compact Flash
lists the 1606 Extension SAN Switch memory specifications.
Table 20 1606 Extension SAN Switch memory
Install memory
Memory type
2 GB
Main Memory (DDR2 SORDIMM SDRAM)
4 MB
Boot Flash
1 GB
Compact Flash
Facility requirements
To ensure correct operation, the facility where the switch is in use must meet the requirements
shown in
.
Table 21 Facility requirements
Requirements
Type
8/8, 8/24, 8/80, Encryption, and 1606 Extension SAN Switches
—Primary AC input: 100–240
VAC, 2.0 A, 47–63 Hz; switch autosenses input voltage.
Electrical
8/40 SAN Switch
—Primary AC input: 90–264 VAC; switch autosenses input voltage.
FCoE Converged Network Switch
—Primary AC input: 85–264 VAC; input line frequency 47–63
Hz.
Adequate supply circuit, line fusing, and wire size, as specified by the electrical rating on the
switch nameplate.
Circuit protected by a circuit breaker and grounded in accordance with local electrical codes.
Electrical interference less than the levels in the standards listed in
8/8 and 8/24 SAN Switches
—A minimum of 24 cu ft/min of airflow is available to the air intake
vents on the nonport side of the switch.
Thermal
8/40, 8/80, Encryption, and 1606 Extension SAN Switches
—Air flows from the nonport side
to the port side. A minimum airflow of 79.8 cu m/hr (47 cu ft/min) is available in the immediate
vicinity of the switch.
Ambient air temperature does not exceed 40ºC (104ºF) while the switch is operating.
74
Technical specifications