Hettich AvanFit YOU 300, Инструкция по эксплуатации и сборке

Страница: 20 / 96

20
• Move left-hand (fixed side) pressing on cylinder into positi-
on. To do this, proceed as follows:
a) Undo clamping screw.
b) Raise pressing on cylinder and turn it through 90° into the
engagement slot.
c) Tighten clamping screw.
7. Operation
7.1 Operating mode
One possible operating mode is available for operating the ma-
chine:
• Manual operating mode
(Automatic drawer assembly on actuating the two hand
switch system)
7.2 Preparing machine
To put the machine into operation, it is imperative to follow this
activation sequence:
• No guards from servicing work still in place.
• Electrical connection ensured.
• Pneumatic connection ensured.
• Lubricate the guides if necessary.
• Check for leakages in the pneumatic system
• Fit support for rear panel. For this, tighten the four screws on
the front of the support.
Note
From the aspect of organisation, it is always
necessary to define which persons are authorised
to put the machine into operation and operate it.
i
en