16
14. Push in the E-Stop pushbutton and turn the key
switch to the OFF position. The E-stop and relay
output LEDs in the receiver should turn off.
15. If transmitter and receiver function properly, the
system is ready for use.
16. Install the cover onto the receiver.
17. If the receiver or transmitter does not operate
properly, or if the crane/machine does not react
as directed, shut the entire system down and
refer to the Troubleshooting Section. If necessary,
contact Hetronic or your Dealer.
.
HOLDING THE TRANSMITTER
Hold the transmitter with the control panel facing you.
Be sure that you are able to easily read any text and
understand the operation symbols.
The procedures described in the following paragraphs
must be completed before the radio remote control
system is activated. These checks must be performed
at least once a day, before the start of any operation
and at all shift changes.
VISUAL CHECK
Always check the transmitter for any physical damage
before any operation.
• Check equipment for wear or damage.
• Check rubber cuffs and pushbutton caps for wear
or damage.
IMPORTANT:
Never operate a transmitter with worn or
damaged parts. Replace immediately with only
Hetronic parts. Contact Hetronic or your Dealer.
START-UP PROCEDURE
1. Be sure that all safety measures required by the
equipment manufacturer have been followed.
2. Turn on power to the receiver.
3. Place the key switch on the transmitter in the
OFF position and the E-Stop pushbutton in the
OFF position (i.e. pull it out).
4. Place a fully charged battery pack into the battery
compartment located at the back of the
transmitter.
5. Turn the key switch to the ON position. The
Power LED on the transmitter flashes GREEN
once and an acoustic pulse sounds to indicate
there is a diagnostic test in progress.The LED on
the transmitter continuously flashes GREEN and
a second acoustic pulse sounds to indicate
successful diagnostic testing.
6. Press the Start pushbutton
7. The system is now ready to use.
IMPORTANT:
To avoid accidental start-up, always
engage the E-stop pushbutton and switch the
transmitter "OFF" when not in use. When the
transmitter is not attached to the operator, the key
switch should be removed and stored in a secure
place.
WARNING:
The Receiver settings are set at
the factory and should be changed by
Hetronic service personnel only. Incorrectly
changing the settings of the receiver could
result in damage to equipment, serious injury
or death.
OPERATION
WARNING:
FAILURE TO FOLLOW
INSTRUCTIONS could result in personal
injury and/or damage to equipment. Read and
understand the safety instructions in all
manuals provided.
WARNING:
FAILURE TO FOLLOW
INSTRUCTIONS could result in personal
injury and/or damage to equipment. Always
hold the transmitter in the proper orientation.
Holding the transmitter improperly while
operating the crane/machine could result in
unexpected crane/machine response.
WARNING:
FAILURE TO FOLLOW
INSTRUCTIONS could result in personal
injury and/or damage to equipment. Test the
"E-STOP" function as described in the
crane/machine manufacturer’s operator
manual before beginning any operation.
Option
1
Option
2
E-Stop
Switch
Key
Switch
Power LED
