13
Each Hetronic radio remote control system is delivered
with two fully charged NiMH batteries. One is inserted
in the battery compartment located on the back of the
transmitter. Refer to the “Charging the Battery” on
page 18 for information on charging a discharged
battery.
FREQUENCY AND ADDRESS SETTINGS
Each Hetronic radio remote control system contains a
radio frequency (RF) unit. Each system consists of a
transmitter RF unit and a receiver RF unit.
The address settings are pre-set at the factory in the
ADMO module. However, if the transmitter coder
board, the base board, or if the entire transmitter or
receiver are replaced, the ADMO address must match
the system.
IMPORTANT:
If the ADMO settings of the transmitter
and receiver do not match, the system will not function.
TG DIG-V1 TRANSMITTER
TG TRANSMITTER
WARNING:
The transmitter coder settings are
set at the factory and should be changed by
Hetronic service personnel only. Incorrectly
changing the settings of the transmitter coder
board could result in damage to equipment,
serious injury or death.
CAUTION:
AVOID INJURY OR DAMAGE -
Operating the transmitter without its antenna
could destroy the final stage of the RF
module. DO NOT attempt to change the
Hetronic pre-set frequency or the 20-bit
address. Personal injury and property
damage could result from transmission
interference and may void the warranty.
Option
1
DK1/17
DK3/11
DK5/13
DK7/15
DK8/16
DK6/14
DK4/12
DK2/18
DK10/26
DK28/20
DK9/25
DK27/19
Option
2
S1
S2
S3
S4
S5
S6
S7
S8
S9
S10
S11
S12
1. Upper Housing
2. Lower Housing
3. Start Push-button
4. Horn Pushbutton
5. Top Bezel and Membrane
6. Power LED
7. Motion Push-button
8. Carrying Belt Fastener
9. Battery
10. E-Stop Push-button
11. Key Switch
12. Key Cap
13. Option Push-buttons
14. Option select LEDs
1
3
2
4
5
6
7
8
9
10
11
12
13
14
