14
This section describes the steps to properly label the
transmitter for operation.
Placing the Pushbutton Labels
If your TG transmitter came with pushbutton labels,
insert them into the transmitter as shown below.
1. Remove the pushbutton cover from the
pushbutton base.
2. Remove the pushbutton label.
3. Place the new label into the pushbutton cover
face down, so the label shows when the cover is
turned right-side up.
4. Snap the pushbutton base back into the cover.
5. Repeat these steps for each label to be replaced.
6. If necessary, clean the transmitter housing with
rubbing alcohol to remove any traces of dirt, oil or
other debris.
7. Place the pushbuttons on the transmitter
according to the layout for your application.
8. Remove the adhesive strip from the back of the
bezel and carefully place it on the enclosure.
9. Press the bezel firmly into place.
NOTE:
DO NOT use any type of glue or adhesive to
secure the bezel to the transmitter housing. Incorrect
adhesives can damage the transmitter and will void the
warranty.
Check the following list before turning the transmitter
on.
• Be sure there is a fully charged battery pack in
the transmitter.
• Push in the E-Stop button.
• Be sure the motion pushbuttons are in their OFF
(neutral) positions.
TEST THE SYSTEM
• Remove the cover from the receiver.
• Position yourself in front of the receiver so that all
LEDs and connections are visible.
TRANSMITTER SETUP
1. Bezel with Membrane
2. Pushbutton Cover
3. Pushbutton Label
4. Pushbutton Base
5. Housing
5
4
2
3
1
WARNING:
FAILURE TO FOLLOW
INSTRUCTIONS could result in personal
injury and/or damage to equipment. Read and
understand the safety instructions in all
manuals provided.
Testing or service must be performed by
authorized personnel only.
There must be no load on the crane/machine.
Clear the crane/machine operating area of
obstructions.
TEST PROCEDURES
WARNING:
FAILURE TO FOLLOW
INSTRUCTIONS could result in personal
injury and/or damage to equipment. Read and
understand the safety instructions in all
manuals provided.
Testing or service must be performed by
authorized personnel only.
There must be no load on the crane/machine.
Clear the crane/machine operating area of
obstructions.
